Hello all, I was hoping to find somebody with some Unitech product experience. I'm looking to connect the MS180-1RG scanner to the TE-900 ECR. I've been workin on this problem for about a month now, and was able to get some of the information that I need.

The best information I've found so far was on this forum here

So far I'm near positive I have the casio set up properly. In P03 I used 0198 [sub] then 12000 [ca] [sub]. I understand this sets the baud rate to 9600.

However, the settings on the Unitech are labeled a bit differently than the metrologic or other scanners. I'll list them and bold the options I have currently selected

Baud Rate: 300 600 1200 2400 4800 9600 19200 38400
Party: Even / Odd / Mark / Space / None
Data bit: 7 / 8
Handshaking: Ignore / RTS Enable at Power up / RTS Enabled in Communication
ACK/NAK: Off / On
BCC Character: Off / On
Time Out: 1sec / 3sec / 10sec / Unlimited

One thing to note here is that I see no setting labeled (or including) "Stop Bit"

In the thread linked above, no2morrow mentioned he also changed some of the barcode settings. He mentioned:


I have lots of fun settings that I know nothing about here, but nothing similar to what no2morrow posted. Regarding the three types mentioned, I have the following settings:

UPC-A
Disable / Enable
Leading Digit: Send / No Send
Check Digit: Send / No Send

UPC-E
Disable / Enable
Leading Digit: Send / No Send
Check Digit: Send / No Send
Zero Expansion: On / Off
NSC=1: Disable / Enable

EAN-13
Disable / Enable
Leading Digit: Send / No Send
Check Digit: Send / No Send
ISBN: Enable / Disable

Any Ideas