hi just lost all my setting for my er3110 trying to reprogram
my layout as six clarks key 1-6 set on the left side how do i reset my clarks to these, so that my staff just have to press there name

_________________
thanks

wayne

Need to look out my 3110 book.
Before you start though, how did it lose all its programming? Did someone do a master reset or was it left unplugged for a while? I'm asking because if the machine has never had the back up battery changed before, the original will be well past its best and could be leaking its corrosive innards all over the main board!

looks as it been master reset as it had a new battery last year
ans was pluged in all the time

_________________
thanks

wayne

I'll tell you what to do once I get my manual out. It's filed (i.e. I have to find it! Don't get asked about 3110s much now).

thanks a lot for your help thank you

_________________
thanks

wayne

Ok. Got manual now.
Did you have your clerk keys on the top line like this: Starting from the left top, Rcpt feed, Journal feed, Clerk 1, Clerk 2, etc.
OR
Starting top left again and working down: Rcpt feed, Clerk 1, Clerk 2, etc.

No bottom left go up starting 1@ bottom

_________________
thanks

wayne

Ok. To put the clerk keys into those positions, turn the key to the SRV position. Then 950 . X 76 (then press the key position). Then 77 (then press key position). Then press 78 (then press key position), etc up to 81 for the six clerks. Once you've pressed the last key position finish the programming by pressing the TL button.

Ok i will try it thanks for your help

_________________
thanks

wayne

thanks that work fine
just one more thing i have programed the plu and tried to set them to direct button but when i use the button i get a error ( entry error).
i have set one key as a plu button!
so if i enter the plu code and then press the plu key the item enters fine


can you help me on this

thanks wayne

_________________
thanks

wayne