hi i have done all the programing required to the till, before i can start using it need to clear all the data from x2/z2 report so i can start from fresh,

The Init2 is the procedure to wipe out all reporting data without affecting programming.



That is the number "8" ten times.

_________________
Cashregistersite.com

Low rate Credit Cards

thanks that worked great, last thing is there a way i can program the other till by copying the program to save reprograming it, i have cf card formated ready, thanks

its almost sorted i done this but after it has complete im left with INIT 0000000000

heres what i have done

Via CF card (to send the IPL data to CF card)
Operation
1. Set the mode switch to OFF position.
2. Open the CF card slot cover and insert the CF card securely.
(Please check that the CF card is vacant. Refer to the “System utility section in PGM7”.)
3. Turn the mode switch to PGM position.
4. Enter “7” and press <SUBTOTAL>.
5. Enter “170” and press <SUBTOTAL>.
6. Enter “49” and press <CASH>.
(In case of quitting, press <SUBTOTAL> instead of <CASH>.)
7. Turn OFF the register and pull out the CF card.
Via CF card (to send the IPL data to register)
Operation
1. Set the mode switch to OFF position.
2. Open the CF card slot door and insert the CF card securely.
3. While holding down the <JOURNAL FEED>, turn the mode switch to PGM position.
4. Release <JOURNAL FEED> after the register shows “INIT”.
5. Enter “44449999” and press <SUBTOTAL>.
6. Enter “20” and press <SUBTOTAL>.


what do i do next